телефон 0086-371-86162511

Свяжитесь с нами сейчас для круглосуточной поддержки клиентов.

Электронная почта

[email protected]

Project Reports On Slag Sand

ГОРЯЧИЕ продукты

Sand For Concrete From Steel Mills Induction Furnace

Slag sand The sample used in the study as obtained from local steel mills, no crushing, sieving are any other process/treatment done in it. Its physical composition given in Tables 2. The grading of slag sand found to be of Zone-II as per IS: 383-1970. 4. Aggregate 20 mm graded crushed aggregate from local crushes was used in this study.

Contact

Use of Steel Slag Aggregate in Pavements Report November 2015

2015. 11. 25. project. The proposed project will be constructed in the Northwest Region within a reasonable distance to Nucor facility to make the project economical. The project will include a one mile long test section of steel slag aggregate with the remainder of the project built using conventional HMA with natural aggregates.

Contact

Copper slag as sand replacement for high performance

This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of sand on the properties of high performance concrete (HPC). Eight concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mix) to 100%. Concrete mixes were evaluated for workability,

Contact

Experimental Studies to Investigate Efficacies of Slag as

Title: Experimental Studies to Investigate Efficacies of Slag as Fine Aggregate Substitute Author(s): T. Hemalatha, Arjun S, and B. S. Sindu Publication: Materials Journal Volume: 117 Issue: 5 Appears on pages(s): 241-250 Keywords: M-sand; ordinary portland cement; portland pozzolana cement; river sand; slag aggregate Date: 9/1/2020 Abstract: This study investigates the feasibility of using

Contact

An assessment on volume stabilization of mortar with

2017. 11. 30. This study aims at employing stainless steel oxidizing slag (SSOS) as fine aggregate, replacing river sand in mortar mixtures with various ratios (e.g. 0%, 25%, 50%, 75%, and 100%). The received slag was left outdoor from 1- to 8 months as a treatment before be used as aggregate.

Contact

Ground Granulated Blast Furnace Slag Conclusion

2016. 6. 16. Ground Granulated Blast furnace Slag consist essentially silicates and alumino silicates of calcium. Portland cement is a good catalyst for activation of slag because it contains the three main chemical components that activate slag: lime, calcium sulphate and alkalies. The material has glassy structure and is ground to less than 45 microns.

Contact

A STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH

2015. 10. 28. pastes were done initially. The project was divided into two phases; mixes in phase 1 consisted of natural sand only, while mixes in phase 2 consisted of a combination of natural sand and steel slag sand. The water content was 190L/m3 for phase 1. However, it was increased to 200L/m3 in phase 2 since steel slag sand was used. Three cement contents were

Contact

COIN Project Reports SINTEF

2021. 4. 4. Production and Utilisation of Manufactured Sand. COIN-report 12 Wigum, B.J. (2009) Classification and Particle Properties of Fine Aggregates (< 63µm) Applied as concrete aggregate. COIN-report 32 Wigum, B.J. (2011) Hokksund Quarry Review of the aggregate production. COIN-report 33 Wigum, B.J. (2011)

Contact

project reports on slag sand